Highlander 4WD V6-3.3L (3MZ-FE) (2004)
a. Install the speed sensor rear with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
NOTICE: Prevent foreign matter from attaching to the sensor tip.
b. Install the sensor harness clamps with the 2 bolts to the body and the shock absorber assy.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
NOTICE: Do not twist the sensor wire when instilling the sensor.
c. Push in the sensor wire harness with grommet.
NOTICE: When grommet is set to body, pull the grommet do not pull sensor wire.
d. Connect the speed sensor connector.
5. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
6. INSTALL DECK SIDE TRIM COVER LH
7. CHECK ABS SPEED SENSOR SIGNAL