Highlander 4WD V6-3.3L (3MZ-FE) (2004)
d. Remove the 2 bolts, 2 nuts and throttle body.
e. Remove the gasket.
8. INSTALL THROTTLE BODY ASSY
a. Install a new gasket to the intake air connector.
b. Install the throttle body with the 2 bolts and 2 nuts.
Torque: 11 N.m (112 kgf.cm, 8 ft.lbf)
c. Connect the water by-pass hose No. 3.
d. Connect the water by-pass hose No. 2.
e. Connect the throttle control motor & throttle position sensor connector.
9. INSTALL INTAKE AIR RESONATOR
10. INSTALL AIR CLEANER ASSY
11. INSTALL AIR CLEANER INLET ASSY
12. CHECK CONNECTION OF VACUUM HOSE
13. ADD ENGINE COOLANT
14. CHECK FOR ENGINE COOLANT LEAKS
15. INSTALL V-BANK COVER SUB-ASSY
a. Fit the 2 retainers and install the V-bank cover.
b. Using a socket hexagon wrench 5, tighten the 3 nuts.
Torque: 7.9 N.m (81 kgf.cm, 70 in.lbf)
16. INSTALL FRONT SUSPENSION BRACE SUB-ASSY UPPER CENTER
a. Install the upper brace with the 2 nuts.
Torque: 80 N.m (815 kgf.cm, 59 ft.lbf)