Highlander 4WD V6-3.3L (3MZ-FE) (2004)
8. REMOVE ENGINE MOVING CONTROL ROD
9. REMOVE WATER OUTLET
a. Disconnect the radiator hose inlet.
b. Disconnect the ECT sensor connector.
c. Remove the clamp.
d. Remove the 2 bolts, 2 nuts and 2 washers.
e. Lock the hose clamp as shown in the illustration.Then remove the water outlet together with the water by-pass hose No.1.
f.
Remove the 2 gaskets from the 2 cylinder heads.
10. REMOVE KNOCK SENSOR
a. Disconnect the 2 sensor connectors.
b. Remove the 2 nuts and 2 sensors.