Highlander 4WD V6-3.3L (3MZ-FE) (2004)
1. Make sure that belt cannot be pulled out by over 45 degrees of tilt.
NOTE: Do not disassemble the retractor.
b. Install the floor anchor with the bolt.
Torque: 42.0 N.m (420 kgf.cm, 31 ft.lbf)
NOTE: Do not make the anchor part run onto the protrusion part of the floor panel.
c. Install the rear No.1 seat belt assembly outer with the bolt.
Torque: 42.0 N.m (420 kgf.cm, 31 ft.lbf)