Highlander 4WD V6-3.3L (3MZ-FE) (2004)
7. INSPECT GENERATOR BRUSH HOLDER ASSY
a. 100 A:
Using a vernier caliper, measure the exposed brush length.
Standard exposed brush length: 10.5 mm (0.413 in.)
Minimum exposed brush length: 4.5 mm (0.177 in.)
If the exposed brush length is less than the minimum, replace the brush holder assy.
b. 130 A:
Using a vernier caliper, measure the exposed brush length.
Standard exposed brush length: 10.5 mm (0.413 in.)
Minimum exposed brush length: 4.5 mm (0.177 in.)
If the exposed brush length is less than the minimum, replace the brush holder assy.
8. INSPECT GENERATOR ROTOR ASSY
a. Check that the bearing is not rough or worn.
100 A:
If necessary, replace the rotor assy.
130 A:
If necessary, replace the rotor bearing.