Highlander 4WD V6-3.3L (3MZ-FE) (2004)
/Page-990007.png)
11. INSPECT GENERATOR DRIVE END FRAME BEARING
a. Check that the bearing is not rough or worn. If necessary, replace the bearing.
12. REMOVE GENERATOR DRIVE END FRAME BEARING
a. Remove the 4 screws and retainer plate.
b. Using SST and a wooden block, tap out the bearing.
SST 09950-60010 (09951-00250), 09950-70010 (09951-07100)
13. INSTALL GENERATOR DRIVE END FRAME BEARING
a. Using SST and a press, press in a new bearing.
SST 09950-60010 (09951-00470), 09950-70010 (09951-07100)
