Highlander 4WD V6-3.3L (3MZ-FE) (2004)
10. INSTALL REAR STABILIZER LINK ASSY LH
a. Install the stabilizer link to the shock absorber with the nut.
Torque: 39 Nm (400 kgf-cm, 29 ft. lbs.)
HINT: If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.
11. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
12. INSPECT REAR WHEEL ALIGNMENT
13. CHECK ABS SPEED SENSOR
DISPOSAL
1. DISPOSE OF SHOCK ABSORBER ASSY REAR LH
a. Fully extend the shock absorber rod.
b. Using a drill, make a hole in the cylinder somewhere between A and B as shown in the illustration to discharge the gas inside.
CAUTION:
^
Be careful when drilling because shards of metal may fly about, so always use the proper safety equipment.
^
The gas is colorless, odorless and non-poisonous.