Highlander 4WD V6-3.3L (3MZ-FE) (2004)
/Page-834011.png)
48. INSTALL FRONT SUSPENSION ARM SUB-ASSY LOWER NO.1 LH
a. Install the lower ball joint to the lower suspension arm with the bolt and nut.
Torque: 127 Nm (1,300 kgf-cm, 94 ft. lbs.)
49. INSTALL TIE ROD ASSY LH
a. Install the tie rod end to the steering knuckle with the nut.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
b. Install a new cotter pin.
NOTICE: If the holes for the cotter pin are not aligned, tighten the nut further to 60°.
50. INSTALL SPEED SENSOR FRONT LH
a. Install the flexible hose to shock absorber with the bolt.
Torque: 19 Nm (194 kgf-cm, 14 ft. lbs.)
b. Install the speed sensor to the steering knuckle with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
NOTICE:
^
Be careful not to damage the speed sensor.
^
Prevent foreign matter from being attached.
^
Do not twist the sensor wire when installing the sensor.
51. INSTALL FRONT STABILIZER LINK ASSY LH
a. Install the stabilizer bar link with the nut.
Torque: 74 Nm (760 kgf-cm, 55 ft. lbs.)
HINT: If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.
