Highlander 4WD V6-3.3L (3MZ-FE) (2004)
/Page-835002.png)
6. REMOVE REAR AXLE HUB & BEARING ASSY LH
(a) Remove the 4 bolts and the rear axle hub & bearing assy LH.
7. SEPARATE REAR SUSPENSION ARM ASSY NO.1 LH
(a) Using a jack, raise the rear axle carrier sub-assy LH, as shown in the illustration.
(b) Remove the bolt and nut, and separate the rear suspension arm assy No.1 LH (rear axle carrier side) from the rear axle carrier.
HINT: When removing the bolt, keep the nut from rotating.
8. SEPARATE STRUT ROD ASSY REAR
(a) Remove the bolt and nut, and separate the strut rod assy rear (rear axle carrier side) from the rear axle carrier.
HINT: When removing the bolt, keep the nut from rotating.
