Highlander 4WD V6-3.3L (3MZ-FE) (2004)
13. REMOVE REAR DRIVE SHAFT INBOARD JOINT ASSY LH
(a) Put matchmarks on the inboard joint assy and outboard joint shaft.
NOTICE: Do not punch the marks.
(b) Remove the inboard joint assy from the outboard joint shaft.
(c) Using a snap ring expander, remove the snap ring.
(d) Put matchmarks on the outboard joint shaft and tripod joint.
NOTICE: Do not punch the marks.
(e) Using a brass bar and a hammer, remove the tripod joint from the outboard joint shaft.
NOTICE: Do not tap the roller.
(f) Remove the inboard joint boot, inboard joint boot LH clamp and inboard joint boot LH No.2 clamp.
14. REMOVE REAR DRIVE SHAFT OUTBOARD JOINT BOOT LH CLAMP