Highlander 4WD V6-3.3L (3MZ-FE) (2004)
/Page-854001.png)
Transmission Position Switch/Sensor: Adjustments
PARK/NEUTRAL POSITION SWITCH ASSY (U151E/U151F)
ADJUSTMENT
1. INSPECT SWITCH ASSY, NEUTRAL START
a. Apply the parking brake and turn the ignition switch to the ON position.
b. Depress the brake pedal and check that the engine starts only when the shift lever is set in the N or P position.
c. Check that the back-up light is lit and the reverse warning buzzer sounds only when the shift lever is set in the R position.
If a failure is found, check the park/neutral position switch for continuity.
2. ADJUST SWITCH ASSY, NEUTRAL START
a. Loosen the 2 bolts of park/neutral position switch and set the shift lever to the N position.
b. Align the groove and neutral basic line.
c. Hold the switch in position and tighten the 2 bolts.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
d. After adjustment, perform the inspection described in step 1.
