Highlander 4WD V6-3.5L (2GR-FE) (2008)
Repair/Removal
62. REMOVE FRONT DECK SIDE TRIM COVER RH
HINT: Use the same procedure for the RH side and the LH side.
63. DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH
HINT: Use the same procedure for the RH side and the LH side.
64. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
65. REMOVE INDOOR ELECTRICAL KEY OSCILLATOR
(a) Using a clip remover, remove the 3 clips and tear off the front floor carpet.
(b) Disconnect the connector.
(c) Remove the clamp and the indoor electrical key oscillator.
Installation
DOOR LOCK: ELECTRICAL KEY OSCILLATOR (for Rear Side): INSTALLATION
INSTALLATION
1. INSTALL INDOOR ELECTRICAL KEY OSCILLATOR
(a) Install the indoor electrical key oscillator with the clamp.
(b) Connect the connector.
(c) Install the front floor carpet with the 3 clips.
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation
3. CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Rear