Highlander 4WD V6-3.5L (2GR-FE) (2008)
(b) Using SST, install the front suspension member body mounting rear cushion RH.
SST: 09830-10010
09830-01010
09830-01020
09830-01030
09830-01060
HINT: Perform the same procedure as the LH side.
3. INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING FRONT CUSHION
(a) Temporarily install a new front suspension member body mounting front cushion while confirming the installation direction.
NOTE: Position the front suspension member body mounting front cushion in the correct direction.
(b) Using SST, install the front suspension member body mounting front cushion as shown in the illustration.
SST: 09830-10010
09830-01010
09830-01020
09830-01030
09830-01060
NOTE: Check that there is no clearance between the front suspension member and the front suspension member body mounting rear cushion.
4. INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING REAR STOPPER
5. INSTALL FRONT SUSPENSION MEMBER BODY MOUNTING FRONT STOPPER
6. INSTALL FRONT SUSPENSION MEMBER DYNAMIC DAMPER
(a) Install the front suspension member dynamic damper with the 2 bolts.
Torque: 29 Nm (296 kgf-cm, 21 ft-lbf)
7. INSTALL FRONT LOWER SUSPENSION ARM LH See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Front Lower
Suspension Arm/Installation
8. INSTALL FRONT LOWER SUSPENSION ARM RH
HINT: Perform the same procedure as the LH side.
9. INSTALL TRANSVERSE ENGINE MOUNTING INSULATOR
10. INSTALL FRONT FRAME ASSEMBLY