Highlander 4WD V6-3.5L (2GR-FE) (2008)
(2) Install the camshaft timing oil control valve assembly with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Intake side:
(1) Apply a coat of engine oil to a new O-ring and install it onto the camshaft timing oil control valve assembly.
(2) Install the camshaft timing oil control valve assembly with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
3. INSTALL HARNESS PROTECTOR
(a) Connect the 2 studs [A].
(b) Connect the 2 clamps [B].
(c) Connect the 19 connectors [C].
(d) Install the 5 bolts and nut [D].
Torque: 8.3 Nm (84 kgf-cm, 73 in-lbf)
4. TEMPORARILY INSTALL NO. 1 SURGE TANK STAY See: Intake Manifold/Service and Repair/Installation
5. TEMPORARILY INSTALL THROTTLE BODY BRACKET See: Intake Manifold/Service and Repair/Installation