Highlander 4WD V6-3.5L (2GR-FE) (2008)
(c) Install the 12 screws.
3. INSTALL REAR COOLING UNIT EXPANSION VALVE
(a) Using a 4 mm hexagon wrench, install the rear cooling unit expansion valve with the 2 hexagon bolts.
Torque: 3.5 Nm (36 kgf-cm, 31 in-lbf)
(b) Install the grommet.
(c) Engage the 3 claws and install the plate.
4. INSTALL BLOWER MOTOR CONTROLLER
(a) Install the blower motor controller with the 2 screws.
5. INSTALL REAR BLOWER MOTOR SUB-ASSEMBLY
(a) Install the rear blower motor sub-assembly with the 3 screws.
6. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY