Highlander 4WD V6-3.5L (2GR-FE) (2008)
Horn Switch: Service and Repair
Removal
HORN: STEERING PAD SWITCH: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment See: Body and Frame/Interior Moulding
/ Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair.
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization
2. REMOVE LOWER NO. 3 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Removal
3. REMOVE LOWER NO. 2 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Removal
4. REMOVE STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Removal
5. REMOVE STEERING PAD SWITCH ASSEMBLY
(a) Disconnect the pad switch connector from the spiral cable.
(b) Remove the screw.
(c) Disengage the 2 pins and remove the steering pad switch.
(d) Remove the screw.
(e) Disengage the 2 pins and remove the steering pad switch assembly.