Highlander 4WD V6-3.5L (2GR-FE) (2008)
/Page-562003.png)
(1) Connect a vinyl tube to either one of the bleeder plugs.
(2) Depress the brake pedal several times, and then loosen the bleeder plug connected to the vinyl tube with the pedal depressed (*5).
(3) When fluid stops coming out, tighten the bleeder plug, and then release the brake pedal (*6).
(4) Repeat (*5) and (*6) until all the air in the fluid is completely bled out.
(5) Tighten the bleeder plug completely.
Torque: 8.3 Nm (85 kgf-cm, 73 in-lbf)
(6) Repeat the above procedure for the rest of the wheels to bleed the brake lines.
(e) Bleed the suction line according to "Step 2: Inhalation Line" on the Techstream display.
NOTICE:
-
Bleed the suction line by following the steps displayed on Techstream.
-
Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.
(1) Connect a vinyl tube to the bleeder plug at the right front wheel or the right rear wheel and loosen the bleeder plug.
(2) Operate the brake actuator assembly to bleed the air using Techstream (*7).
NOTICE:
-
During this step, be sure to release the brake pedal.
-
The actuator operation stops automatically in 4 seconds.
(3) Check that the actuator operation has stopped by referring to the Techstream display, and tighten the bleeder plug (*8).
(4) Repeat (*7) and (*8) until all the air in the fluid is completely bled out.
(5) Tighten the bleeder plug completely.
Torque: 8.3 Nm (85 kgf-cm, 73 in-lbf)
(6) For the rest of the wheels, bleed the air in the same way as stated in the above procedure.
Torque: 8.3 Nm (85 kgf-cm, 73 in-lbf)
(f) Bleed the pressure reduction line according to "Step 3: Decrease Line" on the Techstream display.
NOTICE:
-
Bleed the pressure reduction line by following the steps displayed on Techstream.
-
Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.
