Highlander 4WD V6-3.5L (2GR-FE) (2008)
Throttle Body: Service and Repair
Removal
2GR-FE ENGINE CONTROL SYSTEM: THROTTLE BODY: REMOVAL
REMOVAL
1. REMOVE ENGINE UNDER COVER ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Removal
2. REMOVE NO. 1 ENGINE UNDER COVER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
3. DRAIN ENGINE COOLANT See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair
4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
6. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
7. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
8. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
9. REMOVE V-BANK COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
10. REMOVE AIR CLEANER CAP SUB-ASSEMBLY See: Air Cleaner Housing/Service and Repair/Removal
11. REMOVE THROTTLE BODY
(a) Disconnect the throttle body connector and clamp.
(b) Disconnect the 2 water by-pass hoses from the throttle body.
(c) Remove the 4 bolts and throttle body.