Highlander 4WD V6-3.5L (2GR-FE) (2008)
Throttle Body: Service and Repair
Installation
2GR-FE ENGINE CONTROL SYSTEM: THROTTLE BODY: INSTALLATION
INSTALLATION
1. INSTALL THROTTLE BODY
(a) Install a new throttle body gasket to the intake air surge tank.
(b) Install the throttle body with the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the 2 water by-pass hoses.
(d) Connect the throttle body connector and clamp.
2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY See: Air Cleaner Housing/Service and Repair/Installation
3. ADD ENGINE COOLANT See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair
4. INSPECT FOR COOLANT LEAK See: Engine, Cooling and Exhaust/Cooling System/Testing and Inspection
5. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
6. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
7. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
8. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH
9. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH