Highlander 4WD V6-3.5L (2GR-FE) (2008)
Variable Valve Timing Actuator Position Sensor: Service and Repair
Installation
2GR-FE ENGINE CONTROL SYSTEM: VVT SENSOR: INSTALLATION
INSTALLATION
1. INSTALL VVT SENSOR (for Bank 2)
(a) Exhaust side:
(1) Install the VVT sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Intake side:
(1) Install the VVT sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
2. INSTALL VVT SENSOR (for Bank 1)
(a) Exhaust side:
(1) Install the VVT sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Intake side:
(1) Install the VVT sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
3. INSTALL HARNESS PROTECTOR See: Computers and Control Systems/Variable Valve Timing Actuator/Service and Repair/Installation
4. TEMPORARILY INSTALL NO. 1 SURGE TANK STAY See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and
Repair/Installation
5. TEMPORARILY INSTALL THROTTLE BODY BRACKET See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and
Repair/Installation