Highlander 4WD V6-3.5L (2GR-FE) (2008)
/Page-19001.png)
Power Trunk / Liftgate Control Module: Scan Tool Testing and Procedures
WINDSHIELD / WINDOWGLASS: GLASS HATCH OPENER SYSTEM: DATA LIST / ACTIVE TEST
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT: Using Techstream read the DATA LIST allows values or status of switches, sensors, actuators and other items to be read without
removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts
or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.
CAUTION: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these
reference values when deciding whether a part is faulty or not.
(a) Connect Techstream to the DLC3.
(b) Turn the ignition switch on (IG).
(c) Turn on Techstream.
(d) Enter the following menu.
(1) Select: Body / Main Body / Data List.
Main Body:
2. ACTIVE TEST
HINT: Using Techstream to perform ACTIVE TEST allows relays, VSVs, actuators and other items to be operated without removing any
parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is
disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. DATA LIST information can be displayed
while performing ACTIVE TEST.
(a) Connect Techstream to the DLC3.
(b) Turn the ignition switch on (IG).
(c) Turn on Techstream.
(d) Enter the following menu.
(1) Select: Body / Main Body / Active Test.
Main Body:
