Highlander 4WD V6-3.5L (2GR-FE) (2008)
/Page-20001.png)
Power Trunk / Liftgate Control Module: Pinout Values and Diagnostic Parameters
WINDSHIELD / WINDOWGLASS: GLASS HATCH OPENER SYSTEM: TERMINALS OF ECU
TERMINALS OF ECU
1. CHECK MAIN BODY ECU
(a) Disconnect the 1A, 1D and 1F Junction block connectors.
(b) Measure the voltage and resistance between the specified terminals of the wire harness side connectors and body ground.
Standard voltage:
Standard resistance:
If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Reconnect the 1A, 1D and 1F Junction block connectors.
(d) Measure the voltage according to the value(s) in the table below.
Standard voltage:
