Highlander 4WD V6-3.5L (2GR-FE) (2008)
/Page-2000010.png)
40. REMOVE REAR POWER OUTLET SOCKET COVER (for LH Side) See: Power and Ground Distribution/Auxiliary Power Outlet/Service and
Repair/Rear Power Outlet Socket/Removal
41. REMOVE REAR DECK TRIM COVER (for LH Side without Remote Folding Function) See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair/Removal
42. REMOVE RECLINING REMOTE CONTROL BEZEL (for LH Side with Remote Folding Function) See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair/Removal
43. REMOVE ROPE HOOK ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
44. REMOVE NO. 2 DECK SIDE TRIM HOOK (for LH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal
45. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service
and Repair/Removal
46. REMOVE FRONT DECK SIDE TRIM COVER See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
47. DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY See: Seat Belt Systems/Seat Belt/Service and Repair/Rear No. 1 Seat Outer
Belt Assembly/Removal
48. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal
49. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal
50. REMOVE REAR AIRBAG SENSOR
(a) Disconnect the connector from the rear airbag sensor.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
(b) Remove the bolt and disengage the pin, and remove the rear airbag sensor.
NOTE: Loosen the bolt while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR: INSTALLATION
INSTALLATION
1. INSTALL REAR AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the battery negative (-) cable is disconnected.
CAUTION: Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.
