Highlander 4WD V6-3.5L (2GR-FE) (2008)
Steering Mounted Controls Assembly: Service and Repair
Installation
METER: STEERING PAD SWITCH: INSTALLATION
INSTALLATION
1. INSTALL STEERING PAD SWITCH ASSEMBLY
(a) Engage the 2 pins and install the steering pad switch assembly.
(b) Install the screw.
Torque: 2.4 Nm (24 kgf-cm, 21 in-lbf)
(c) Engage the 2 pins and install the steering pad switch assembly.
(d) Install the screw.
Torque: 2.4 Nm (24 kgf-cm, 21 in-lbf)
(e) Connect the pad switch connector to the spiral cable.
2. INSTALL STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
3. INSTALL LOWER NO. 3 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Installation
4. INSTALL LOWER NO. 2 STEERING WHEEL COVER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Installation
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization
6. INSPECT STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
7. INSPECT SRS WARNING LIGHT See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System