Highlander 4WD V6-3.5L (2GR-FE) (2008)
/Page-428001.png)
Seat Position Sensor: Testing and Inspection
SUPPLEMENTAL RESTRAINT SYSTEM: SEAT POSITION SENSOR: ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
1. INSPECT SEAT POSITION SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check See: Restraint Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble
Codes/DTC Check / Clear.
2. INSPECT SEAT POSITION SENSOR (VEHICLE INVOLVED IN COLLISION)
(a) Perform a diagnostic system check See: Restraint Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble
Codes/DTC Check / Clear.
(b) Even if an airbag was not deployed, check if there is any damage to the seat position sensor.
If there are any defects as mentioned below, replace the seat position sensor with a new one:
-
Cracks, dents or chips on the sensor housing.
-
Cracks or other damage to the connector.
CAUTION: For removal and installation procedures of the seat position sensor, be sure to follow the correct procedure.
