Highlander 4WD V6-3.5L (2GR-FE) (2008)
/Page-1347010.png)
4. INSTALL REAR DIFFERENTIAL CASE BEARING (for RH Side)
(a) Using SST and a press, install the rear differential case bearing to the rear differential case.
SST: 09636-20010
5. INSTALL REAR DIFFERENTIAL CASE BEARING (for LH Side)
(a) Using SST and a press, install the rear differential case bearing to the rear differential case.
SST: 09636-20010
6. INSPECT RUNOUT OF DIFFERENTIAL RING GEAR
(a) Install the rear differential case to the rear differential carrier sub-assembly, and install the 2 rear differential side gear shaft plate washers so
that there is no play in the bearing.
(b) Align the matchmarks on the bearing cap and differential carrier, and install the 2 bearing caps.
NOTE: Make sure the right and left bearing caps are not interchanged.
(c) Tighten both rear differential bearing caps with the 4 bolts.
Torque: 79 Nm (800 kgf-cm, 58 ft-lbf)
(d) Using a dial indicator, measure the runout of the differential ring gear.
Maximum runout:
0.07 mm (0.0028 in.)
If the runout exceeds the specified maximum value, remove the ring gear and check the runout of the differential case.