Highlander 4WD V6-3.5L (2GR-FE) (2008)
Windshield: Service and Repair
Installation
WINDSHIELD / WINDOWGLASS: WINDSHIELD GLASS: INSTALLATION
INSTALLATION
1. INSTALL NO. 2 WINDSHIELD GLASS STOPPER
(a) Using a brush or sponge, coat the application area of the No. 2 windshield glass stoppers with Primer G.
NOTICE:
-
Do not apply too much primer.
-
Allow the primer to dry for 3 minutes or more.
-
Throw away any leftover Primer G.
HINT: If an area other than that specified is coated by accident, wipe off the primer with a clean piece of cloth before it dries.
(b) Install 2 new No. 2 windshield glass stoppers onto the glass as shown in the illustration.
NOTE: Only 2-piece type No. 2 windshield glass stoppers are supplied. Use the 2-piece type stoppers even if a 1-piece type was originally
installed.
2. INSTALL NO. 1 WINDSHIELD GLASS STOPPER
(a) Install 2 new No. 1 windshield glass stoppers to the vehicle body, as shown in the illustration.
NOTE: Only 2-piece type No. 1 windshield glass stoppers are supplied. Use the 2-piece type stoppers even if a 1-piece type was originally
installed.
3. INSTALL WINDOW GLASS ADHESIVE DAM
(a) Using a brush or sponge, coat the application area of the window glass adhesive dam with Primer G.
NOTICE:
-
Do not apply too much primer.
-
Allow the primer coating to dry for 3 minutes or more.
-
Throw away any leftover Primer G.
(b) Install a new window glass adhesive dam onto the windshield glass, as shown in the illustration.