Highlander 4WD V6-3.5L (2GR-FE) (2008)
6. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH
(a) Operate the wiper and stop the windshield wiper motor at the automatic stop position.
(b) When reinstalling:
(1) Clean the wiper arm serrations.
(2) Clean the wiper pivot serrations with a wire brush.
(c) Install the front wiper arm and blade assembly LH with the nut to the position shown in the illustration.
Torque: 24 Nm (245 kgf-cm, 18 ft-lbf)
HINT: Hold the wiper arm by hand when tightening the nut.
(d) Operate the front wipers while spraying washer fluid onto the windshield glass. Make sure that the front wipers function properly and the
wipers do not come into contact with the vehicle body.