Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
/Page-1043002.png)
a. Press the switches at both ends of garage door opener simultaneously for 20 seconds.
HINT: When transferring to deletion mode, LED (red) blinks in 6 Hz cycle.
b. When releasing the switch within 10 seconds after transferring to deletion mode, all the registered codes will be erased.
HINT: Press the switch until blinking in 6 Hz cycle stops, so that the default code for check is set.
Code deletion timing chart
3. INSPECT GARAGE DOOR OPENER
a. Press the switch and check that each LED (red) lights up. Even if only one switch is found not to light up, replace it.
4. INSPECT GARAGE DOOR OPENER REGISTRATION AND TRANSMITTING
HINT: Use the home link tester made by KENT MORE for this test. As it is necessary to record the code of the hand held transmitter, customer's
code will be erased. When the inspection completes, please register the customer's again.
