Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
3.
SHORTEN THE CHILD PROTECTION LOCK LEVER.
(a)
Use a file or Dremel(R) to grind down the portion of the lever that protrudes from the spacer.
NOTE:
The supplied spacer may not fit flush against the door panel. The supplied spacer should bottom out on the lever.
NOTE:
If the lever is already flush or does not extend beyond the special tool (washer) the lever is okay and further modification for that particular
lever is not necessary.
NOTE:
Do not damage the body.
4.
REMOVE THE SUPPLIED SPACER.
5.
ROUND OUT THE EDGES ON CHILD PROTECTION LOCK LEVER
(a)
Use high grit sandpaper (# 2000 or higher) or Dremel(R) Rotary Tool with # 511 Abrasive Buffs Bit or equivalent to round off and smooth