Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
Parking Brake Cable: Service and Repair
Parking Brake Cable Assembly No. 1
REPLACEMENT
1. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSY LOWER
2. REMOVE INSTRUMENT PNL INSERT SUB-ASSY LWR LH
3. REMOVE FRONT DOOR SCUFF PLATE LH
4. REMOVE COWL SIDE TRIM SUB-ASSY LH
5. REMOVE FRONT FLOOR FOOTREST
6. REMOVE PARKING BRAKE CABLE ASSY NO. 1
a. Release the parking brake pedal.
b. Remove the clip and disconnect the parking brake cable assy No. 1 from the parking brake pedal assy.
c. Remove the nut and parking brake cable assy No. 1 from the parking brake equalizer.
d. Turn up the floor carpet and remove the 2 bolts and parking brake cable assy No. 1 from the body.
7. INSTALL PARKING BRAKE CABLE ASSY NO. 1
a. Install the parking brake cable assy No. 1 to the body with the 2 nuts.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)