Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
/Page-1198001.png)
Fuel Gauge: Testing and Inspection
INSPECT FUEL RECEIVER GAUGE
a. Inspect the circuit.
1. Disconnect the connector from the sender gauge.
2. Turn the ignition switch ON, then check the position of the receiver gauge needle.
Needle position: EMPTY
3. Connect terminals 2 and 3 on the wire harness side connector of main fuel sender gauge and between terminals on the wire harness side.
4. Turn the ignition switch ON, then check the position of the receiver gauge needle.
Needle position: FULL
