Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
Seat Belt Reminder Lamp: Testing and Inspection
INSPECT SEAT BELT WARNING LIGHT (Driver's seat)
a. Check the operation.
1. Turn the ignition switch ON and check that the warning light lights up.
2. Fasten the outer belt to the inner belt and check that the warning light lights out.
3. Disconnect the connector from the buckle switch and ground terminal on the wire harness side connector.
4. Turn the ignition switch ON and check that the warning light lights up.
INSPECT SEAT BELT WARNING LIGHT (W/ Passenger's seat belt warning)
a. Check the operation.
1. Turn the ignition switch ON, then with the passenger being seated on the passenger seat, check that the seat belt warning light in the heater
control panel lights.
b. Inspect the circuit.
1. Disconnect the connector from the front seat inner belt.
2. Connect terminals 1 and 4 on the wire harness side connector.
3. Turn the ignition switch ON and check the warning light.
Warning light: Light up