toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Customer Interest for Airbag Sensor Assembly: > < Ignition Control Module|Testing and Inspection|Page 361
Page 1
background image

Airbag Sensor Assembly: All Technical Service Bulletins
Air Bag System - MIL ON/DTC B1140 and B1141 Set

ELECTRICAL
EL012-03

August 29, 2003

Title:
M.I.L. "ON" DTC B1140 & B1141

Models:
'01 - '03 Highlander

Introduction 

Under severe cold conditions (approximately 0°F/-18°C or below), some 2001 - 2003 model year Highlander vehicles equipped with side airbags may
exhibit a M.I.L. "ON" condition with a Diagnostic Trouble Code (DTC) B1140 or B1141 stored in the Center Airbag ECU memory. To prevent a M.I.L.
"ON" condition, the Center Airbag ECU has been updated.

Applicable Vehicles
^

2001 - 2003 model year Highlander vehicles produced BEFORE the Production Change Effective VINs shown below.

Production Change Information

Parts Information

Repair Procedure

Refer to the appropriate repair manual procedure for diagnosis of the specific M.I.L. "ON" DTC present. Confirm that the ambient temperature during
the M.I.L. "ON" was at or below 0°F (-18°C). If no trouble is found, after performing diagnosis for the M.I.L. "ON", replace the Center Airbag Sensor
Assembly (Airbag ECU) with the new part number provided above.

Warranty Information

Applicable Warranty *:

This repair is covered under the Toyota Comprehensive Warranty. This warranty is in effect for 36 months or 36,000 miles, whichever occurs first, from
the vehicle's in-service date.

*

Warranty application is limited to correction of a problem based upon a customer's specific complaint.

Customer Interest for Airbag Sensor Assembly: > < Ignition Control Module|Testing and Inspection|Page 361