Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
/Page-783004.png)
7. INSPECT FIELD COIL
a. Using an ohmmeter, check that there is continuity between the lead wire and field coil brush lead.
If there is no continuity, replace the field frame.
b. Using an ohmmeter, check that there is no continuity between the field coil brush lead and field frame.
If there is continuity, repair or replace the field frame.
8. INSPECT BRUSH
a. Using vernier calipers, measure the brush length.
Standard length: 15.5 mm (0.61 in.)
Minimum length: 8.5 mm (0.335 in.)
If the length is less than minimum, replace the brush holder and field frame.
