Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
10. INSTALL REAR AXLE CARRIER SUB-ASSY LH
a. Install the rear axle carrier with the 2 bolts and nuts.
Torque: 255 Nm (2,600 kgf-cm, 188 ft. lbs.)
HINT: Insert the bolt from the rear side of the vehicle and install the nut.
11. TEMPORARY TIGHTEN REAR SUSPENSION ARM ASSY NO. 1 LH
a. Install the rear suspension arm No. 1 to the rear axle carrier with the bolt and nut, temporarily tighten the bolt.
HINT: Insert the bolt from the front side of the vehicle and while fixing the nut, turn and install the bolt.
12. TEMPORARY TIGHTEN REAR SUSPENSION ARM ASSY NO. 2 LH
a. Install the rear suspension arm No. 2 to the rear axle carrier with the bolt and nut, temporarily tighten the bolt.
HINT: Insert the bolt from the rear side of the vehicle and while fixing the nut, turn and install the bolt.
13. INSTALL REAR AXLE HUB & BEARING ASSY LH
14. INSTALL SKID CONTROL SENSOR WIRE
15. INSTALL REAR DISC
16. INSTALL REAR DISC BRAKE CALIPER ASSY LH
17. TEMPORARY TIGHTEN STRUT ROD ASSY REAR
18. STABILIZE THE SUSPENSION
19. FULLY TIGHTEN REAR SUSPENSION ARM ASSY NO. 1 LH
20. FULLY TIGHTEN REAR SUSPENSION ARM ASSY NO. 2 LH
21. FULLY TIGHTEN STRUT ROD ASSY REAR
22. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
23. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
24. CHECK ABS SPEED SENSOR SIGNAL