Landcruiser V8-4.7L (2UZ-FE) (2000)
a. Using a heat light, heat the moulding to 40 - 60 degrees C (104 - 140 degrees F).
NOTE: Do not heat the moulding excessively.
b. Cut the adhesive tape with a knife.
NOTE:
-
If reusing the moulding, take care not to damage the moulding.
-
Do not damage the body.
c. Using a screwdriver, remove the moulding.
HINT: Tape the screwdriver tip before use.
4. REMOVE UPPER REAR OUTSIDE REAR DOOR MOULDING
a. Using a heat light, heat the moulding to 40 - 60 degrees C (104 - 140 degrees F).
NOTE: Do not heat the moulding excessively.
b. Cut the adhesive tape with a knife.
NOTE:
-
If reusing the moulding, take care not to damage the moulding.
-
Do not damage the body.
c. Remove the moulding.
5. REMOVE OUTSIDE QUARTER MOULDING
a. Using a heat light, heat the moulding to 40 - 60 degrees C (104 - 140 degrees F).