Landcruiser V8-4.7L (2UZ-FE) (2000)
HINT: If the hydraulic brake booster has been disassembled, disconnect the brake line from the hydraulic brake booster or if the reservoir
becomes empty, bleed the hydraulic brake booster.
a. Disconnect the 2 connectors from the hydraulic brake booster.
b. Connect the actuator checker (SST) to the hydraulic brake booster side wire harness via the sub-wire harness (SST), as shown in the chart
below.
SST 09990-00150, 09990-00480
HINT: Connect the connector with the label of "AIR BLEED" attached to the connector of actuator checker.
c. Connect the red cable of the checker to the battery positive (+) terminal and the black cable to the negative (-) terminal.
d. Turn the ignition switch OFF, depress the brake pedal more than 40 times.
HINT: When a pressure in power supply system is released, reaction force becomes light and stroke becomes longer.
e. Turn the ignition switch ON, check that the pump stops after 30 to 40 seconds
NOTICE: When the pump does not stop, repeat step (d) and (e) again.
f.
With the ignition switch remained ON, depress the brake pedal more than 20 times.
g. Observe the procedure in step 4 and bleed the right and left front wheel caliper.