Landcruiser V8-4.7L (2UZ-FE) (2000)
Blower Motor Relay: Testing and Inspection
Blower Motor Control Relay
INSPECTION
1. REMOVE BLOWER MOTOR CONTROL RELAY
a. Disconnect the connectors.
b. Remove the screw and relay.
2. INSPECT BLOWER MOTOR CONTROL RELAY
Connect the connector to the relay and inspect the wire harness side connector from the back side as shown in the chart.
Test condition:
-
Turn ignition switch to ON
-
Blowerspeed:HI
If circuit is not as specified, replace the relay.
3. INSTALL BLOWER MOTOR CONTROL RELAY
a. Install the relay with the screw.
b. Connect the connectors.