Landcruiser V8-4.7L (2UZ-FE) (2000)
1. DISCONNECT FUEL PUMP INERTIA SWITCH CONNECTOR
Take off the front floor carpet, and disconnect the connector.
2. REMOVE FUEL PUMP INERTIA SWITCH
Using a torx driver (T30), remove the 2 bolts and switch.
3. INSPECT FUEL PUMP INERTIA SWITCH
a. Check that there is no continuity between terminals with the reset switch OFF.
b. Check that there is continuity between terminals with the reset switch ON.
If operation is not as specified, replace the switch.
4. REINSTALL FUEL PUMP INERTIA SWITCH
NOTE: Check that the reset switch ON position.
5. RECONNECT FUEL PUMP INERTIA SWITCH CONNECTOR
6. CHECK THAT START ENGINE