Landcruiser V8-4.7L (2UZ-FE) (2000)
a. Place matchmarks on the torsion bar spring, anchor arm and torque arm.
b. Measure the dimension "A" between the anchor arm adjusting bolt end and the frame as shown.
HINT: Use the measurement for a reference when installing the anchor arm.
c. Loosen the anchor arm bolt until the spring tension is free and measure the anchor arm bolt "B".
HINT: Use the measurement for a reference when installing the anchor arm.
d. Remove the anchor arm adjusting bolt, anchor arm swivel and anchor arm adjusting seat.
e. Remove the torsion bar spring with the anchor arm.
f.
Remove the anchor arm from the torsion bar spring.
4. REMOVE TORQUE ARM
Remove the 2 nuts, bolt and torque arm.
INSTALLATION
1. INSTALL TORQUE ARM
Install the bolt, torque arm and 2 nuts.
Torque: 225 Nm (2,300 kgf-cm, 166 ft. lbs.)
2. INSTALL TORSION BAR SPRING WITH ANCHOR ARM
HINT: There are right and left matchmarks on the rear end of the torsion bar springs. Apply a light coat of MP grease to the spline of the torsion
bar springs.
a. New torsion bar spring:
Install a new torsion bar spring and anchor arm.