Landcruiser V8-4.7L (2UZ-FE) (2000)
e. Coat the threads of the set bolt with adhesive.
Adhesive: Part No. 08833-00070, THREE BOND 1324 or equivalent
f.
Tighten the shift fork set bolt.
Torque: 20 Nm (200 kgf-cm, 15 ft. lbs.)
g. Tighten the 4 bolts uniformly, a little at time.
Torque: 24 Nm (240 kgf-cm, 18 ft. lbs.)
2. INSTALL COVER
a. Clean the contacting surfaces of any FIPG material using gasoline or alcohol.
b. Apply FIPG to the cover.
FIPG: Part No. 08826-00090, THREE BOND 1281 or equivalent
HINT: Install the cover within 10 minutes after applying FIPG.
c. Install the cover with the 3 bolts.
Torque: 18 Nm (185 kgf-cm, 13 ft. lbs.)
3. INSTALL REAR DIFF. LOCK POSITION SWITCH
Install the diff. lock position switch with a new gasket.
Torque: 40 Nm (410 kgf-cm, 30 ft. lbs.)
4. CONNECT CONNECTORS AND TUBE
HINT:
-
The depth of the insertion of the bleeder tube into the hose is approximately 15 mm (0.59 inch).
-
Take care that the water or the equivalent will not adhere to the connectors and hose.
5. INSTALL NO. 2 ACTUATOR PROTECTOR
Install the No. 2 actuator protector with the 2 nuts.
Torque: 36 Nm (367 kgf-cm, 27 ft. lbs.)
6. INSTALL NO. 1 ACTUATOR PROTECTOR
Install the No. 1 actuator protector with the nut and bolt.
Torque: 15 Nm (150 kgf-cm, 11 ft. lbs.)
7. CANCEL REAR DIFFERENTIAL LOCK POSITION
a. Connect the cable to the negative terminal of the battery.