Landcruiser V8-4.7L (2UZ-FE) (2000)
d. Disconnect the cable from the negative terminal of the battery.
2. REMOVE NO. 1 ACTUATOR PROTECTOR
Remove the nut, bolt and No. 1 actuator protector.
3. REMOVE NO. 2 ACTUATOR PROTECTOR
Remove the 2 nuts and No. 2 actuator protector.
4. DISCONNECT CONNECTORS AND TUBE
5. REMOVE REAR DIFF. LOCK POSITION SWITCH
6. REMOVE COVER
a. Remove the 3 bolts.
b. Using a brass bar and hammer, remove the cover.
7. REMOVE ACTUATOR
a. Remove the shift fork set bolt.
b. Remove the 4 bolts.
c. Using a screwdriver, pry out the actuator.
INSTALLATION
1. INSTALL ACTUATOR
a. Clean contacting surfaces of any FIPG material using gasoline or alcohol.
b. Apply FIPG to the actuator.
FIPG: Part No. 08826-00090, THREE BOND 1281 or equivalent
HINT: Install the actuator within 10 minutes after applying FIPG.
c. Install the actuator to the differential and match the shaft with the shaft fork hole.
d. Clean the threads of the set bolt and shaft fork with the white gasoline.