Landcruiser V8-4.7L (2UZ-FE) (2000)
/Page-880003.png)
3. DISCONNECT BRAKE LINES
a. Using SST, disconnect the brake line and remove the clip.
SST 09023-00100
Torque: 15 Nm (150 kgf-cm, 11 ft. lbs.)
b. Employ the same manner described above to the other side.
4. DISCONNECT PARKING BRAKE CABLES
a. Remove the 2 clips, pin and disconnect the parking brake cable from the bellcrank.
b. Employ the same manner described above to the other side.
5. REMOVE AXLE SHAFTS
a. Remove the 4 nuts.
Torque: 123 Nm (1,250 kgf-cm, 90 ft. lbs.)
b. Pull out the axle shaft assembly and remove the O-ring.
NOTICE: Be careful not to damage the oil seal.
c. Employ the same manner described above to the other side.
6. DISCONNECT REAR PROPELLER SHAFT
a. Place matchmarks on the propeller shaft and differential flange.
b. Remove the 4 nuts, bolts, washers and disconnect the propeller shaft.
Torque: 106 Nm (1,080 kgf-cm, 78 ft. lbs.)
c. Support the propeller shaft securely.
