Landcruiser V8-4.7L (2UZ-FE) (2000)
b. Using a hammer, tap the yoke until there is no clearance between the bearing outer race and snap ring.
9. INSTALL FLANGE YOKE TO SLEEVE YOKE (OR PROPELLER SHAFT)
a. Align the matchmarks on the propeller shaft and flange yoke or flange yoke and sleeve yoke.
b. Install the flange yoke to the sleeve yoke (or propeller shaft).
HINT: Install 2 new spider bearings and snap ring on the flange yoke side in the procedure described above.
10. CHECK SPIDER BEARING
a. Check that the spider bearing moves smoothly.
b. Check the spider bearing axial play.
Maximum bearing axial play: 0 mm (0 inch)
HINT: When replacing the spider bearing, be sure that the grease fitting assembly hole is facing to the direction shown in the illustration.