Landcruiser V8-4.7L (2UZ-FE) (2000)
8. REMOVE DRIVE SHAFT
a. Using a brass bar and hammer, remove the drive shaft.
NOTICE: Be careful not to damage the boot, dust cover and oil seal.
b. Using a screwdriver, remove the snap ring from the inboard joint tulip.
HINT: At the time of installation, please refer to the following items.
-
Coat the oil seal lip with MP grease.
-
Before installation, set a new snap ring with opening side facing downward.
-
After installation, check that the drive shaft cannot be pulled out by hand.
INSTALLATION
Installation is in the reverse order of removal.
HINT: After installation, check the ABS speed sensor signal.
Disassembly and Reassembly