Landcruiser V8-4.7L (2UZ-FE) (2000)
2. INSTALL BEARING CASE
Position the backing plate on the bearing case and using a press and 2 socket wrenches, install the 4 serration bolts.
3. INSTALL OUTER OIL SEAL
a. Using SST and a hammer, install a new oil seal.
SST 09950-60020 (09951-00810), 09950-70010 (09951-07100)
b. Coat MP grease to the oil seal lip.
4. INSTALL OIL DEFLECTOR
Position a new gasket and oil deflector on the axle shaft and install a washer and nut to a new hub bolt, as shown in the illustration, and install the
5 hub bolts by torquing the nut.
5. INSTALL AXLE SHAFT TO BACKING PLATE
a. Install the backing plate, plate washer and bearing retainer on the axle shaft.
b. Using SST and a press, install the axle shaft into the backing plate.
SST 09631-12090, 09950-60020 (09951-01030)
6. INSTALL SNAP RING TO AXLE SHAFT
Using a snap ring expander, install a new snap ring.