Landcruiser 4WD L6-3955cc 4.0L OHV (3F-E) (1988)
Voltage at ECU Wiring connectors
NOTE:
-
Perform all voltage measurements with the connectors connected.
-
Verify that the battery voltage is 11 V or above when the ignition switch is "ON".
2. MEASURE RESISTANCE OF ECU WIRING.
CAUTION:
-
Do not touch the ECU terminals.
-
The tester probe should be inserted into the wiring connector from the wiring side.
Check the resistance between each terminal of the wiring connector.
-
Disconnect the connectors from the ECU.
-
Measure the resistance between each terminal of the wiring connectors.