Landcruiser 4WD L6-4.5L (1FZ-FE) (1993)
/Page-1183002.png)
CAUTION
to prevent damage to the internal attaching clip, use extreme care when removing the seat track covers. (See illustration).
^
Remove rear attaching bolts.
^
Move the seat rearward until it reaches the seat track stops and remove the 2 front seat track covers and attaching bolts.
^
Detach the power seat wire harness connector located under the seat cushion (see illustration).
^
Remove seat from vehicle using care to protect the leather material and the seat cushion protector.
^
Place seat on a bench top with suitable cloth between the seat and the bench top.
^
Remove seat back board by removing the 2 attaching screws and pulling the seat back board downward (see illustration).
DISASSEMBLE SEAT COMPONENTS:
^
Remove the plastic side cover by removing the 3 attaching screws and disengaging the plastic attaching clip.
Note:
the front 2 screws are the machine screw thread type while the rear screw is the self tapping type (see illustration).
