Landcruiser 4WD L6-4.5L (1FZ-FE) (1993)
/Page-1071003.png)
a. Disconnect the 2 connectors.
b. Disconnect the airbag connector.
c. Remove the 4 screws.
7. Remove the spiral cable taking care to not disassemble the cable or apply oil to it.
8. Remove the four column hole cover set bolts.
9. Remove the link joint protector by removing the 2 bolts.
10. Disconnect the sliding yoke sub-assembly by performing the following.
a. Place matchmarks on the yoke sub-assembly and the worm gear valve body shaft.
b. Loosen bolt A and remove bolt B.
11. Remove the sliding yoke sub-assembly by removing the bolt A.
12. Remove the tilt steering column assembly after first disconnecting the three connectors then removing the two column assembly set nuts and two
set bolts.
INSTALLATION
1. Install the steering column assembly by torqueing the 2 column assembly set nuts and 2 set bolts to 25 Nm (18 ft. lbs.) and then connecting the
three connectors.
2. Install the sliding yoke sub-assembly by temporarily tightening the bolt A.
3. Connect the sliding yoke sub-assembly by performing the following.
a. Align the matchmarks on the yoke sub-assembly and worm gear valve body shaft.
b. Tighten bolt B to 34 Nm (25 ft. lbs.).
c. Tighten bolt A to 34 Nm (25 ft. lbs.).
4. Install the link joint protector by tightening the two bolts to 12 Nm (9 ft. lbs.).
5. Tighten the four column hole cover set bolts to 13 Nm (9 ft. lbs.)
6. Install the spiral cable.
7. Install the combination switch with spiral cable by first tightening the 4 screws then connecting the airbag connector and then connect the 2
connectors.
8. Install the upper and lower column covers by tightening the 5 screws.
9. Install the no.2 heater to register duct.
10. Install the instrument lower finish panel by tightening the 4 panel set screws then connecting the hood lock control cable and fuel lid control cable.
11. Insert the center spiral cable by performing the following.
a. Check that the front wheels are facing straight ahead.
b. Turn the cable counterclockwise by hand until it becomes harder to turn the cable, then rotate the cable clockwise about three turns to align the
